Each connection of a VPN endpoint has its own page in Lighthouse. A connection is the tunnel to one other site. Its page shows that site’s address and networks, the security settings, and the values to enter on the device at the other end. To add a connection, see Manage a VPN endpoint.
Open a connection’s page
- Open the VPN endpoint’s page. See Manage a VPN endpoint.
- In the connections list, select the connection’s name.
Read the page
The header shows the connection’s name and status, then the other site’s address and the endpoint, for example To 198.51.100.10 · on office-vpn. Back to office-vpn returns to the endpoint. A connection that wasn’t created in Lighthouse carries a Read Only badge and has no menu.
Properties lists:
- Name and Status, for example Active. Pending means a change is still being applied. Down means the tunnel isn’t up: check the device at the other site.
- VPN Endpoint: select it to open the endpoint’s page.
- Peer Address: the public address of the device at the other site, with a button to copy it.
- Peer Networks: the networks at the other site that the tunnel reaches.
- Security Policy: the set of encryption settings chosen when the connection was added.
- ID, with a button to copy it.
Tunnel Parameters lists the IKE and IPsec settings the tunnel uses, such as IKE Version, IKE Encryption and IPsec Encryption, and its tunnel settings, such as DPD Action.
Settings For The Far End lists the values to enter on the device at the other site for this connection. Copy one value at a time, or select Copy All. The pre-shared key isn’t shown here: use the one set for this connection.
Edit or delete the connection
The menu next to the name holds Edit Connection and Delete Connection, the same actions as the connection’s row on the endpoint’s page.
- Edit Connection: change what you need, then select Save. You see Connection updated. The security policy is fixed after creation. A connection can’t be changed while it’s pending.
- Delete Connection: confirm. The tunnel to that site stops, and this can’t be undone. You return to the endpoint’s page.
If something goes wrong
- Connection Not Found means the connection was deleted, or you don’t have access to it. Go back to the endpoint and check its connections.
- Part of this delete didn’t finish, and what’s left is still there. Try again to finish it.